#Masonry stack bond vs running bond full
#Masonry stack bond vs running bond code

The contribution of bed joint reinforcing is also being assessed. This paper presents the results of the first stage of a comprehensive investigation of the performance of typical Australian stack bonded brick masonry subjected to lateral out-of-plane loading under a range of support conditions. However, architects and other designers are increasingly incorporating stack bonded masonry in their designs either as a veneer or a structural element for architectural effect, and in these cases, specific structural design requirements are needed. Learn the basics of brick bonds for your next project. When building a brick patio, walkway, or wall, you need to choose a bond for laying the brick.

#Masonry stack bond vs running bond code

Its use in Australia is not encouraged and consequently no specific design provisions are included in the Australian masonry structures code AS3700. When building a brick patio, walkway, or wall, you need to choose a bond for laying the brick.

#Masonry stack bond vs running bond full

This bonding pattern leads to continuous vertical joints running the full height of the wall resulting in a weak form of construction particularly when subjected to lateral out-of-plane loading. The common, or American, bond follows the same pattern as the running bond. Stack Bond Figure 1Definition of Stack Bond Masonry. The bricks are placed side-by-side creating strong, visual lines in the ground plain. In stack bond masonry, heavy concentrated loads will be carried down to the support by the particular vertical tier or column of masonry under the load, with little distribution to adjacent masonry. This is the most simple of all the paving patterns. This gives a more random look instead of the more uniform 1/2 brick look. Compressive strength is similar for stack and running bond construction. In this case, the bricklayer begins with a 1/3 of a brick instead of half a brick. Since the courses alternate, with centers alternating from course to course, the pressure works down to offer stability. Structurally it offers plenty of strength to the wall. It’s simple and straightforward even if it isn’t fancy. MASIA, MARK1 SIMUNDIC, GORAN2 PAGE, ADRIAN3ġ) Associate Professor, The University of Newcastle, Centre for Infrastructure Performance and Reliability, Structural Testing Manager, The University of Newcastle, Centre for Infrastructure Performance and Reliability, Emeritus Professor, The University of Newcastle, Centre for Infrastructure Performance and Reliability, bonded masonry is a form of construction in which the masonry units in adjacent courses are aligned vertically above one another. Note: in some cases, the running bond can work with a 1/3 pattern instead of a 1/2. The running bond is the most common type of brick pattern, one seen in walls and buildings all over the globe.